Configuration Editing - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 11 – Full wiring using all accent LEDs and a recharge port/kill key combo. This wiring will allow most features of Spark Color 2™ to be
experienced without getting into super complex wiring. Note that the resistor/diode is needed for the red color.
5.

CONFIGURATION EDITING

Once Spark Color 2™ has been wired according to the wiring above then it will work immediately with the default
configuration. However, changing the fonts and effects is completely possible and encouraged by using the
Igniter™ Config Editor. The following section will go through installing and using the editor to modify Igniter™
configuration.
5.1. INSTALLATION
To install the application, launch the .msi file from the installer zip file. You can get the file from SaberIgniter.com.
A version is also included on the micro SD card that came with Igniter™, but I recommend going to the site to get
the newest version in case any enhancements have been made to the program. Click through the wizard until the
application launches.
5.2. COPY FILES TO YOUR MACHINE
Before opening Spark Color 2™ Config Editor you will need to copy the files you want to edit from the micro SD
card to your local computer. First, insert your micro SD card into your computer using your SD card reader. If you
do not currently have one, I recommend this cheap one off eBay:
Then, open a new window and find a place to put a new Igniter directory. In this example the Igniter directory will
be placed right on the root c:\ drive. Create a new directory and name it "Igniter". Then, inside that directory,
create another folder with the name of your saber. In this example, "Saber1" will be used.
Micro SD card.
Page | 16