Tascam DR-40 Reference Manual page 106

14 – Messages
Message Meaning and response
The system file is missing. This unit requires a system file for operation. When this message appears, press the
File Not Found
ENTER/MARK
Make Sys File
Invalid SysFile The system file required to operate this unit is invalid. When this message appears, press the
Make Sys File to automatically create a system file.
Something might be wrong with the card. Change the card.
Invalid Card
Change Card
Writing to the card timed out.
Write Timeout
Backup files on the card to your computer, and format the card.
The card has no remaining capacity. Erase unnecessary files or move them to your computer to make open space.
Card Full
The position selected for divide is not suitable (too close to the beginning or end of a file).
Can't Divide
The file is larger than the designated size, or the recording time has exceeded 24 hours when the total number of
Max File Size
folders and files was already at the limit (5000).
The total number of folders and files exceeds 5000. Erase unnecessary files or move them to your computer.
File Full
The card could not be handled properly. Replace the card.
Card Error
MP3 files cannot be divided.
Current File MP3
The file is read only and cannot be erased.
File Protected
No SD card is in the unit. Install a recordable SD card.
No Card
There is no file that can be played back. The file might be damaged.
No PB File
There is no playback file, so DIVIDE and OVERDUB cannot be executed.
No MUSIC File
You cannot overdub a WAV file with a sampling frequency of 96 kHz in MP3 format. Change the recording format to
Cannot overdub!
WAV.
See REC setting
The MS decoder is being used on the input. To use it on monitoring, on the
Using by Input
OFF
Now DUAL REC
In dual recording mode, change the input level control setting on the
106
TASCAM DR-40
button to automatically create a system file.
.
ENTER/MARK
REC MODE MS DECODE
screen, set
REC MODE
screen.
button
to