Inspur NF5180M5 User Manual page 138

service.
3) Status LED on front panel is abnormal
Description: The server is under normal operation, but the status LED on front panel turns red.
Suggestions:
a. Firstly confirm which LED is abnormal according to the previous chapter about the
LEDs on the front panel.
b. If the system failure LED is abnormal, check whether the system runs normally; if
the system runs normally, you can login to the BMC Web interface to view the BMC
logs, to check whether there are errors reported.
c. If the power failure LED is abnormal, check whether the power module LED
is normal; if the power module LED is normal, you can login to the BMC Web
interface to view the BMC logs, to check whether there are errors reported.
d. If other LEDs are abnormal, you can login to the BMC Web interface to view the
BMC logs, to check whether there are errors reported.
e. If above operations could not resolve the problem, please contact Inspur customer
service.
4) Power module LED is off or red
Description: The server is under normal operation, but a certain power module LED is off or red.
Suggestions:
a. Firstly check whether all power cables are normal, and plug in the power cables
again.
b. If the fault still exists, insert the power module again.
c. If shutdown is allowed, you could exchange the two power modules to judge
whether it is a power module fault.
d. If above operations could not resolve the problem, please contact Inspur customer
service.
5) HDD status LED is abnormal
Description: The server is under normal operation, but the HDD status LED is off or red.
Suggestions:
a. If it is caused by manual operations, restore the array through RAID configuration.
b. If there is no manual operations, check whether the HDDs are identified normally.
If the server is configured with an RAID card, login to the RAID management
interface to check whether there is an HDD failure.
132