How To Wire The One-Touch Connector Plug - Toshiba AJ65VBTCU-68ADVN User Manual

4 SETUP AND PREPARATION BEFORE OPERATION

4.10 How to Wire the One-Touch Connector Plug

4.10.1 Wiring procedures for the one-touch connector
Plug body
[Termination using soldering]
Disentangle and twist the shield
and cut them to proper length.
Termination
using soldering
[Termination using crimping sleeves]
Disentangle and twist the shield
and cut them to proper length.
Termination using
crimping sleeves
Example: Butt joint
1 For the applicable cable size, refer to
section 3.2.
(To the next page)
4 - 16
This section describes the way to wire the one-touch connector plug.
Refer to section 2.3 for more information on the types and specifications of the one-
touch connector plugs which conform to the AJ65VBTCU-68ADVN/ADIN.
The following are the wiring procedures for the one-touch connector.
Plug cover
Metal contact
V+
V-
SLD
One-touch connector
plug for analog I/O
Connect the applicable
cable ( 1).
V+
V-
SLD
One-touch connector
plug for analog I/O
Connect the applicable
cable ( 1).
1) Check the connector.
Check that the plug cover is attached to the plug body.
Note: Do not push the plug cover into the plug body.
Once pressed, the plug cannot be used any more.
2) Processing for analog input cable
Strip the cable 3cm or more and perform the processing
indicated at left.
If the electric wire lengths are not even, trim their ends with a
nipper to the same length so as to insert them neatly into a
connector.
MELSEC-A
4 - 16