Table of Contents
Advertisement
5 PROGRAMMING
5 PROGRAMMING
5.1 Programming Procedure
5
5 - 1
The programming procedure, basic read/write programs, and program examples for
the AJ765VBTCU-68ADVN/ADIN are described.
When utilizing the program example introduced in this chapter for an actual system,
fully verify that there are no problems in controllability in the target system.
Refer to the user's manual of the master module used for the master module, to
Section 3.6 for the remote registers, and to the AnSHCPU/AnACPU/AnUCPU/QCPU
(A mode) Programming Manual (Dedicated Instructions) for details of the dedicated
instructions.
Create a program which executes the AJ765VBTCU-68ADVN/ADIN analog/digital
conversion by following the procedure below:
START
A/D conversion enable/prohibit specification
Input range setting
Perform average processing?
Yes
Average time, number of times setting
Specify the channel for which average
processing will be performed.
Read digital output value
END
When using the QCPU (Q mode), you can use the remote device station
initialization procedure registration function to make settings. When using the ACPU,
QCPU (A mode) or QnACPU, use the sequence program to make settings.
No
Initial settings
MELSEC-A
5 - 1
Advertisement
Table of Contents
