Table of Contents
Advertisement
5 PROGRAMMING
Procedure Execution Condition
Initial data processing request flag (RX18) turns on
Initial data processing request flag (RX18) turns off
Initial data setting completion flag (RX19) turns on
5 - 5
(2) Initial setting by remote device station initialization procedure
registration
(a)
Setting the target station number
Set the station number to which initial setting will be made.
Set the target station number to "1".
(b)
Setting the procedure registration
When the initial data processing request flag (RX18) turns on and the
remote device station initialization procedure registration (SB0D) is set, the
following data are registered to the AJ65VBTCU-68ADVN/ADIN.
A/D conversion enable/prohibit specification: channenls 1, 2: enable
(RWw0 :0003
CH.1 to CH.4 input range setting : channel 1: 0 to 5V
(RWw1: 31
Average processing setting : channel 1: sampling processing
(RWw3: 200
CH.2 average time, number of times setting: channel 2: 16 times (RWw5: 10
Initial data processing completion flag (RY18) is turned on.
Initial data setting request flag (RY19) is turned on.
Initial data processing completion flag (RY18) is turned off.
Initial data setting request flag (RY19) is turned off.
(c)
Setting results
The setting results are shown below.
POINT
For the case where the remote device station initialization procedure registration
function is not used but a sequence program is used to make setting, refer to the
user's manual of the used master module.
Execution
)
H
: channel 2: user range setting 1
)
H
: channel 2: average processing, average number of
)
H
MELSEC-A
times
)
H
5 - 5
Advertisement
Table of Contents
