Matrox 6150 Encoder User Manual page 29

Maevex 6100 encoder
LED color
No LED (black)
Green (solid)
Green (slow blink)
Green (fast blink)
Amber (solid)
Amber (slow blink)
Amber (fast blink)
Red (solid)
Maevex 5150 encoder and 5150 decoder
LED color
No LED (black)
Green/Red (flashing)
Green
Green (flashing)
Red (flashing)
Red
Amber
Amber (flashing)
6100 encoder
Device isn't powered. Make sure your card is properly
installed. Also, make sure your system isn't in power saving
mode (see "Step-by-step installation", page
For more information, contact your vendor
support", page 53).
Card is active.
Card is rebooting.
Configuration reset in process.
Card is in maintenance mode.
Card is rebooting and is in maintenance mode.
Card is updating the firmware.
Card has detected a fatal error. Try restarting your system. If,
after restarting your system, the LED is still red, contact your
vendor for technical support
53).
5150 encoder
Device isn't powered.
Device is initializing.
Device is ready.
Encoding and streaming.
No valid audio/video input
signal detected.
Fatal error detected.
Configuration reset was
performed. Device requires
maintenance.
Configuring or updating
firmware.
18).
(see "Customer
(see "Customer support", page
5150 decoder
Device isn't powered.
Device is initializing.
Device is ready.
Decoding network stream.
Device isn't in use.
Fatal error detected.
Configuration reset was
performed. Device requires
maintenance.
Configuring or updating
firmware.
Matrox Maevex Series – User Guide 29