Validating Network Discovery - Matrox 6150 Encoder User Manual

Network connector
The network connectors on your product use indicator lights (LEDs) to
provide information on the network activity and presence. The following
describes the different network connector LEDs.
LED color
No LED (black)
Green (flashing)
Orange

Validating network discovery

Maevex devices are initially assigned their IP addresses through DHCP (Dynamic Host Control
Protocol). After connecting your devices, we recommend verifying that all your devices are discovered
by the network.
Windows 10/8.1/7 – To make sure all your devices are discovered by the network:
Windows 10 – Click
all the Maevex devices connected are listed.
Windows 8.1 – From the
Windows 7 – Click
Devices
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking on the prompt at the top of your Windows Explorer
window. These two features must be enabled for PowerStream Plus software to detect the Maevex
devices.
After validating your connection setup, install Matrox PowerStream Plus software
Matrox PowerStream Plus software", page
30 Matrox Maevex Series – User Guide
Network activity
No data transfer in progress
or no network detected.
Data transfer in progress.
—
Start
Start
. Under
Network Other Devices
Start
, make sure all the Maevex devices connected are listed.
File Explorer Network
screen, go to
All Apps
, make sure all the Maevex devices connected are listed.
Acessories Windows Explorer
34).
Network
activity
Network presence
No communication
established.
—
Network communication
established.
. Under , make sure
Other Devices
Windows System File Explorer
. Under
Network
(see "Installing
Network
presence
Other