Hardware Pack - Exerpeutic 1302.7 Owner's Manual

ASSEMBLY
TOOL
Multi Hex Tool with Phillips
Screwdriver
1 PC
STEP 1
1a. Installing the Front Stabilizer – Align the Front Stabilizer (7) onto the front curve of
the Main frame (1). Make sure the transport wheels are positioned toward the front and
parallel to the floor. Install two Carriage Bolts (9) from the bottom, and on the other ends
of the bolts attach two Curve Washers (11) and two Cap Nuts (12). Use the Multi Hex
Tool with Phillips Screwdriver to tighten the Cap Nuts (12) until secure.
1b. Installing the Rear Stabilizer – Align and Install the Rear Stabilizer (8) onto the rear
curve of the Main frame (1) using two Carriage Bolts (9), two Big Curve Washers (11),
and two Cap Nuts (12). Securely tighten the Cap Nuts (12) with the Multi Hex Tool with
Phillips Screwdriver provided.

HARDWARE PACK

(9) Carriage Bolt
(11) Curve Washer (12) Cap Nut
4 PCS
4PCS 4PCS
10