Siemens SIWAREX FTA Device Manual page 108

Weighing Functions
Name
Dosing filter type BYTE
Dosing filter limit BYTE
frequency
Tare / Zero setting
Tare / Zero setting mode BYTE
Tare / Zero setting cycle BYTE
Reserve 3 WORD
Tare min. weight REAL
Tare max. weight REAL
Cycle time for zero TIME
setting
Step control / check stop
Step control through BYTE
digital input 1
Step control through BYTE
digital input 2
5-96
Type Address Default
DBB022 0
DBB023 2
0
DBB024 0
DBB025 0
DBB026 0
DBB028 0
DBB032 0
DBB036 300000
msec
DBB040 0
DBB041 0
Range of Values / Explanation
Filter type for dosage control
0: critically damped
1: Bessel-Filter
2: Butterworth Filter
Other definitions not permitted.
0: No filter
1: fg = 20Hz
2: fg = 10Hz
3: fg = 5Hz
4: fg = 2Hz
5: fg = 1Hz
6: fg = 0,5Hz
7: fg = 0,2Hz
8: fg = 0.1Hz
9: fg = 0´.05Hz
Other definitions not permitted.
0: No taring, no zero setting at weighing start
1: Zero setting
2: Tare
3: Taring with average value
4: Taring using external entry tare
Other definitions not permitted.
0: Every weighing is nullified or tared
1: Tipping is not nullified or tared
2...99: 2...99 tippings not nullified or tared
Other definitions not permitted.
Reserve 3
Taring or ext. tare entries are only executed if
gross > tare minimum weight
0: No monitoring of the tare minimum weight
Tarring or ext. Tare entries are only executed if
gross < tare maximum weight
0: No monitoring of the tare maximum weight
If 0, then no time controlled zero setting
Unequal 0: Time between two zero settings
Note:
Zero setting / taring is performed after 15min at
the latest with weighing operating mode AWI and
country code "OIML"
Instead of defined command codes for the digital
inputs, step-on conditions can be influenced
through the inputs for dosing control (prerequisite
in DR interface parameters is identification 0xFF).
0: Weighing waits at step 0 if DI1 is active;
1: Weighing waits at step 1 if DI1 is active
2: Weighing waits at step 2 if DI1 is active
...
7: Weighing waits at step 7 if DI1 is active
Other definitions not permitted.
Instead of defined command codes for the digital
inputs, step-on conditions can be influenced
through the inputs for weighing control
(prerequisite in DR interface parameters is
identification 0xFF).
0: Weighing waits at step 0 if DI2 is active;
1: Weighing waits at step 1 if DI2 is active
2: Weighing waits at step 2 if DI2 is active
...
7: Weighing waits at step 7 if DI2 is active
Other definitions not permitted.
Reference
5.16.8
5.16.10
5.16.11
5.16.12
5.16.13
5.16.14
5.16.15
5.16.16
5.16.16
SIWAREX FTA