Releasing Pin Lock - NTT docomo FOMA P906i Instruction Manual

Change PIN1 Code/Change PIN2 Code
You need to have set "PIN1 code entry set" to "ON" to change the PIN1
code.
1
mSettingsLock/SecurityUIM setting
Enter your Terminal Security Code
Change PIN1 code or Change PIN2 code
Enter the current PIN1 code/PIN2 code.
pSee page 132 for the PIN1 code/PIN2 code.
2
Enter a new PIN1 code/PIN2 code (four to eight digits).
pThe entered PIN1 code/PIN2 code is displayed as "_".
3
Enter the new PIN1 code/PIN2 code again.

Releasing PIN Lock

If you enter a wrong PIN1 code/PIN2 code three times in succession on
the display requiring its entry, it is locked and the FOMA phone cannot be
used. In this case, release the PIN1 code/PIN2 code lock and set a new
PIN1 code/PIN2 code.
1
Enter the PUK (PIN unblock code)
(eight digits).
pThe entered unblock code is displayed as "_".
pYou can make emergency calls at 110/119/118 even
from the PUK Entry display.
2
Enter a new PIN1 code/PIN2 code (four to eight digits).
pThe entered PIN1 code/PIN2 code is displayed as "_".
134
3
Enter the new PIN1 code/PIN2 code again.
<Lock All>
Locking your Phone to Prevent Use by
Others
If you set Lock All, you can do no operations other than answering calls
and turning on/off the power.
1 mSettingsLock/SecurityLock all
Enter your Terminal Security Code.
" " and "Lock all" appear and Lock All is set.
pTo release Lock All, enter your Terminal Security Code from the Stand-by
display. Even if you turn off the power, Lock All will not be released.
Information
pYou cannot make calls during Lock All. However, you can make emergency calls at
110/119/118. Select "YES" from the confirmation display for dialing.
pYou can receive calls, but the callers' data such as their names and images stored in
the Phonebook are not displayed except for their phone numbers. Further, the ring
tone sounds in "Pattern 1".
pGPS Location Provision is available even during Lock All.
pIf you fail to release Lock All five times in succession, the power to the FOMA phone
turns off. However, you can turn it on again.
pYou can receive mail messages or Messages R/F during Lock All; however, the
Receiving or Reception Result display for incoming mail messages and Messages R/
F does not appear. The icons such as "
released.
pThe notification icon, desktop icon, and schedule on the desktop disappears during
Lock All. When Lock All is released, the icon reappears.
pThe tickers of i-Channel are not displayed during Lock All.
pThe default Wake-up display appears during Lock All even when an i-motion movie
has been set for the Wake-up display.
pEven if you set Lock All, IC Card Lock is not activated.
", " ", or " " appear after Lock All is