Switching To English - NTT docomo FOMA P906i Instruction Manual

<Power ON/OFF>
Turning Power On/Off
Turn Power On
1
Press and hold h for at least one
second.
After the Wake-up display (see page 116) is displayed,
the Stand-by display appears.
pIf you have stored many Phonebook entries or mail
messages, it may take a while for the display to appear.
pIf Set Time is set, the current date and time are shown.
pWhen "
" is displayed, the FOMA phone is out of the
service area or in the place where the radio waves do
not reach. Move to a location where "
pIf "Starting System Wait a minute" is displayed when
you turn on the power, wait for a while and then
proceed.
When your UIM is replaced (except during Omakase Lock)
Enter the four- to eight-digit Terminal Security Code after turning on the power. When
you enter the correct Terminal Security Code, the Stand-by display appears. If you enter
the incorrect Terminal Security Code five times in succession, the power turns off.
(However, you can turn on the power again.)
When "PIN1 code entry set" of "UIM setting" is set to "ON"
Enter the four- to eight-digit PIN1 code after you turn on the power. When you enter the
correct PIN1 code, the Stand-by display appears. See page 132 for PIN1 code.
When "Auto reset setting" of "Notice call cost" is set to "ON"
(except during Omakase Lock)
Enter the four- to eight-digit PIN2 code after you turn on the power. When you enter the
correct PIN2 code, the Stand-by display appears. If you press r or h without
entering the correct PIN2 code, "Auto reset setting" is set to "OFF" and the Stand-by
display appears. See page 132 for PIN2 code.
" disappears.
Stand-by display
Information
pEach entry display appears in the order of "PIN1 code" → "Terminal Security Code"
→ "PIN2 code".
pThe mail message "未定" has been saved by default. Press
"Display Mail from Inbox" on page 218, you can display the mail.
Turn Power Off
1
Press and hold h for at least two seconds.
The exit display appears and the power turns off.
pYou cannot turn on the power immediately after turning off the power. Wait a few
seconds.
<Select Language>

Switching to English

1
m設定 (Settings)ディスプレイ (Display)
バイリンガル (Select language)
Japanese (日本語) or English (英語)
pThe following functions are different between Japanese display and English
display:
Functions
Info Notice Setting
"Clock" of Display Setting
→ "Day of week"
使いかたナビ (Guide)
Voice Guidance
Information
pWhen you insert the UIM, the "バイリンガル (Select language)" setting is stored on
the UIM.
o twice or operate O +
+ m - 1 5 -
Japanese English
電子音 (Electrical tone) ON
ボイス (Voice) Not available
OFF OFF
Available Not available
Available Not available
Available Not available
45