Upper Front Leg Cover Sets Installation
IMPORTANT: Make sure the Speed Sensor Wire sits under the Left
Upper Front Leg Cover Set and is not pinched during installation.
TIP: In order to gain better access to the screw holes while
assembling the Upper Front Leg Cover Sets, adjust the position of
the Pedal Arm Joints by pushing forward or pulling backward on
the Handle Support Tubes.
• Locate the Upper Front Leg Cover Sets, noting Right and Left
markings. Pair each set over the corresponding Right and Left
Upper Front Leg (Figure 17).
• Use the Step 5 Hardware Kit to install the Upper Front Leg
Cover Sets. Partially tighten 3 × Phillips Head Screws using the
Screwdriver provided on each set as shown. Ensure they are
properly aligned and proceed to fully tighten the Phillips Head
Screws with the Screwdriver
(Figure 17 and Figure 18).
Pedal Arm Joint Cover Sets Installation
• Locate the Pedal Arm Joint Cover Sets, noting Right and Left
markings. Pair each set over the corresponding Right and Left
Pedal Arm Joints (Figure 19).
• Use the Step 5 Hardware Kit to install the
Sets. Partially tighten 2 × Phillips Head Screws on each set as
shown. Ensure they are properly aligned and proceed to fully
tighten the Phillips Head Screws with the Screwdriver
(Figure 19 and Figure 20).
STEP 5
Assemble Cover Sets
Pedal Arm Joint Cover
FIGURE 17
Phillips Head
60
Screw
FIGURE 18
FIGURE 19
Phillips Head
60
Screw
FIGURE 20
Step 5 Hardware
Step 5 Hardware
10