Canon DP-V2411 Instruction Manual page 47

Sub Menu
Reset
1
[ACESproxy (Ver. 1.0.1)] cannot be set in the right screen.
2
You cannot adjust [Contrast] in [Picture Mode] for the right screen if [Picture Mode] has been set differently for the left and right screens. The right
screen's setting will be the same as set for the left screen.
3
You cannot adjust when [User LUT] in [CDL/User LUT] is selected.
4
• When [Global Dimming] is selected, the contrast may change temporarily in order to maintain gradation depending on the image. If this is
undesirable, turn it [Off] and see if it improves.
• You cannot set the right screen using [Picture Mode] if [Picture Mode] has been set differently for the left and right screens. The right screen's
setting will be the same as set for the left screen.
5
• [Custom (xy)] and [Gain R/G/B] or [Bias R/G/B] cannot be selected at the same time.
• When [Gain R/G/B] or [Bias R/G/B] value is adjusted, an asterisk [*] is displayed by color temperature preset mode.
• The displayed color coordinates (x, y) are just a guide and not guaranteed absolute values.
6
• For checking the video captured with Cinema EOS cameras, please refer to the "Parameter of Cinema EOS cameras and DP-V2411
( 73)".
• Setting is disabled when [User LUT] is set to [ARRI LUT 709] and is fixed to [ITU-R BT.709].
• Setting is disabled when [User LUT] is set to [ARRI LUT 2020], [ARRI LUT 2020 PQ 1K] or [ARRI LUT 2020 PQ 2K] and is fixed to [ITU-R
BT.2020].
OK Return [Picture Mode] to factory default. Note that in [User 1–7] mode
Cancel where you are performing calibration, the setting returns to the value after
calibration instead of the factory default.
When selected, the message [Reset Adjustment settings to defaults?]
appears.
[OK]: Performs reset.
[Cancel]: Returns to the previous screen without resetting.
Setting Options (Bold: factory default)
OSD Menu
47