Table of Contents
Advertisement
Mounting the Main Unit on a Stand or Wall
This main unit can be fitted to a stand* or to a wall mount bracket*. Remove the stands beforehand (
* Commercially available.
CAUTION
• For safety, make sure to perform this step with at least two people.
• Make sure that the main unit does not fall during installation/removal.
• Avoid touching the screen during this step as it may damage it.
• When mounting the main unit on a wall, make sure the wall has sufficient strength.
If necessary, apply reinforcement. Also, make sure to check the load capacity of the
stand or wall mount bracket.
• When the video display is placed on a rack or display stand and ventilation around
it is blocked by equipment placed above or below or in a surrounding area, the
operating temperature may increase, causing a failure or overheating. In order to maintain the operating temperature condition of
the video display (0 ˚C to 40 ˚C), make space of at least 1U (4.4 cm) above and below and at least 4 cm (1.6 in.) space from its
back. Make sufficient space from peripheral equipment, secure vents, or install a ventilation fan.
• When installing the video display on a wall, make sufficient space from the wall so that cables are not squeezed or twisted.
1 Attach a commercially available stand or wall mount bracket using the screw holes on the back or side
face of the main unit.
4-M4
Depth 6 (Max.)
Rear
2-M4
Depth 7 (Max.)
Same on the other side
Installation/Connection
13).
15
Side
Unit: mm
Advertisement
Table of Contents
