Temporarily Saving Parameters (Anchor Point Setting) - Canon DP-V2411 Instruction Manual

Temporarily Saving Parameters (Anchor Point Setting)

You can temporarily save parameters for [Contrast], [Brightness], [Chroma], [Sharpness], and [HDR Range]. See
for setting anchor points during CDL adjustment.
1 Open the [Anchor Adjustment] menu.
[Adjustment]
2 Press the jog dial, and when the confirmation screen appears, select [OK].
• The parameter is saved and the anchor point is set.
3 Adjust the image quality again and press the RESET button on the video display.
• Returns you to the anchor point for each function.
Note
• Executing [Adjustment] [Reset] or [System Settings]
to their factory default values.
• When calibration is executed, the values are saved as anchor points.
Enlarging the display (Zoom function) (
The zoom display position can be adjusted, and the zoom magnification (2x, 4x, 8x) can be selected.
1 Open the [Zoom] menu.
[Display Settings]
2 Select [Zoom Preset] using the jog dial.
• Select a preset zoom display.
3 Select [Position] using the jog dial.
• The zoom adjustment screen is displayed.
-
To move the display position: Move the jog dial (
-
To return to the center: Press the RESET button.
4 When adjustments are completed, press the jog dial.
• The screen returns to the original OSD menu.
Note
• When magnifying the image and the OSD menu is not being displayed, you can set the magnification ratio by pressing the jog
dial.
[Anchor Adjustment]
Last used value
Anchor point
[Reset All Settings] resets saved anchor points and the settings return
[Zoom]
Current value
57)
or rotation).
Operating the Video Display
43
Zoom 2 [x4]
23