Using Rarp - Printronix Integrated Network Interface Card User Manual

Chapter 5
Unix NIC Configuration
3. Under the Subnet Mask heading, enter the NIC subnet mask.
NOTE: If you would like to communicate with the NIC from across
4. Click the Submit button when done and physically repower the

Using RARP

RARP allows you to dynamically assign an IP address to the NIC
upon bootup. To configure the NIC with its TCP/IP settings using
RARP:
1. On your RARP server, make an entry in the /etc/ethers file for
2. Start the RARP daemon on the RARP server if not already
3. Power on the NIC so that it immediately sends out an RARP
112
routers, you will need to fill in an entry within the "Routing"
section. Please see "Communicating Across Routers" on
page 114 for further details.
print server to make sure the new settings are in effect.
the NIC.
Syntax:
ethernetaddress NICIPaddress
Example:
00:08:96:07:00:60 192.75.11.9
running. If it is running, send an HUP signal to it with the kill
command:
Syntax:
kill -HUP pid
where pid is the process ID of the RARP daemon.
request. Wait one minute to allow the address assignment
process to complete. You should see the STAT LED on the NIC
interface slow down, indicating it knows about an IP address to
use.