Printronix Integrated Network Interface Card User Manual page 254

Chapter 12
Complete Command List
< len-type > indicates the selected preamble length ("long", "short"or
"default").
< sleep-time > indicates the power-save sleep-time in milliseconds.
If power-save is disabled (time is set to zero), "normal (power-save
off)" displayd.
< key-num > is the number identifying one of the four encryption
keys, starting from one. Encryption is disabled if "Encryption
disabled" displayd.
<auth-method> is the authentication method e.g. open, shared,
kerb, leap.
<auth-user-name> is the authentication method user name.
<auth-password> is the authentication method password.
< power > is a percentage indicating the approximate fraction of full
power.
< option-list > is a list of options that are enabled (disabled options
are not shown).
< profile > is the 802.11g/b wireless mode in use.
<wpa-mode> is the WPA wireless mode selected.
<wpa-cipher> is the selected WPa cipher setting.
<wpa-passphrase> is the WPA passphrase represented as *
characters if configured.
<country-code> is the currently configured country setting that is
used to determine valid channel settings with which the 802.11g
wireless NIC is used to communicate with an access point.
< status > is the current access point association status
("disassociated" or "associated with <MAC address>")
< comms-quality > indicates the strength or quality (in percent) of the
wireless signal.
NOTE: The "list stored ifc" command does not display the "Status"
list kerberos
For Wireless NIC with Symbol RF cards only.
250
or "Quality" lines.