Configuration Using The Control Panel - Printronix Integrated Network Interface Card User Manual

Chapter 2
Configuration Tools

Configuration Using The Control Panel

You can set NIC settings from the printer control panel.
CAUTION
When the printer is first powered on, E-NET INIT. displays on
the control panel. To prevent a loss of NIC configuration
information, do not change the NIC settings while this
message displays. When the initialization is complete, E-NET
READY displays and you can safely change the NIC settings
from the control panel.
1. You can set any of three listed parameters from the printer
2. Power on the printer. E-NET INIT. displays when the printer is
3. Verify the current NIC firmware version number.
4. From the control panel, navigate to the IP Address, Netmask,
5. Place the printer online to start the NIC IP Address, Subnet
24
control panel. These parameters are located in the Ethernet
Address or Wireless Address menu.
powered on. Configuration can be done after E-NET READY
displays.
If you need to update the printer firmware, you must do so now.
After the update is complete, you must restart this instruction
from the beginning. Your printer's User Manual includes
instructions for upgrading the printer firmware. The process of
upgrading the printer firmware will automatically upgrade the
NIC firmware to the appropriate level.
and Gateway Address (Subnet Mask) menu options and enter
the appropriate values. You must press the ↵ (Enter) key after
inputting each segment of the IP Address, Subnet Mask, and
Gateway Address.
Mask, and Gateway Address update process. This process will
reboot the printer and may take several minutes. Wait until
E-NET READY displays on the control panel.