Printronix L1524 Operator's Manual page 37

Fuser Cleaner Felt
The fuser cleaner felt should be
replaced each time a new toner bottle is
opened, except when replacing starter
toner. The cleaner felt should also be
replaced when toner has built up on the
felt and begins to flake off.
Be sure to monitor print quality and
condition of the cleaner felt. Replace the
fuser cleaner felt if print quality
deteriorates and caked toner is found on
the cleaner felt.
The fuser operates at extremely high
temperatures. The fuser and fuser
cleaner felt may be very hot. Use caution
when performing this procedure.
Refer to the adjacent figure and perform
these steps:
Raise the top of the printer by
firmly pressing the button on the
left of the front panel.
2
Open the fuser cleaner felt cover.
This cover is hinged and will not
be removed.
3
Remove the old cleaner felt by
lifting it straight up and out the
top of the fuser.
4
Place the new fuser cleaner felt in
the top of the fuser and close the
fuser cleaner felt cover.
5
Close the printer cover.
Operator's Guide
replacing printer consumables
warning
Fuser Cleaner Felt
Fuser Cleaner
Felt Cover (shown
in the open position)
27