Printronix L1524 Operator's Manual page 25

Tractor Feed
The fuser operates at extremely high
temperature. Avoid touching the fuser.
Refer to the adjacent figure and perform
these steps:
Raise the top of the printer by firmly
pressing the button on the left side
of the front panel.
2
Open the rear cover of the fuser
unit by rotating it back and down.
3
Pull and remove the tractor feed
strips from between the fuser rollers
or the tractor feed strips between
the tractors.
4
At the closest perforation, tear off
the paper and pull it out from the
back of the fuser rollers in the fuser
unit.
Pull the jammed paper toward the rear
cover of the fuser unit only. Pulling the
paper back over the rollers may damage
the top of form sensor.
Be careful not to scratch or nick the
rollers when removing the jammed
paper.
5
Reload the paper. Refer to the
"Loading Paper" section.
6
Close the rear cover of the fuser
unit.
7
Close the top cover of the printer
and wait for the printer to warm up.
8
Press ON LINE. Printing will
resume.
Operator's Guide
clearing paper jams
warning
OPC Drum
caution
Tractor
Feed
Strip
Perforation
Fuser
Unit
Rear Cover
15