Table of Contents
Advertisement
The page includes the following fields:
• LAG -- The LAG number included in the VLAN.
• LAG VLAN Mode -- The LAG VLAN mode. Possible values are:
• General -- The LAG belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q
mode).
• Access -- The LAG belongs to a single, untagged VLAN.
• Trunk -- The LAG belongs to VLANs in which all ports are tagged (except for an optional single native VLAN).
• PVID -- Assigns a VLAN ID to untagged packets. The possible field values are 1-4095. VLAN 4095 is defined as
per standard and industry practice, as the discard VLAN. Packets classified to this VLAN are dropped.
• Frame Type -- Packet type accepted by the LAG. Possible values are:
• Admit Tag Only -- Only tagged packets are accepted by the LAG.
• Admit All -- Tagged and untagged packets are both accepted by the LAG.
• Ingress Filtering -- Enables or disables Ingress filtering by the LAG. Ingress filtering discards packets that are
destined to VLANs of which the specific LAG is not a member.
• Current Reserve VLAN -- The VLAN currently designated by the system as the reserved VLAN.
• Reserve VLAN for Internal Use -- The VLAN selected by the user to be the reserved VLAN if not in use by the
system.
Portocol Group
The Protocol Group page provides parameters for configuring frame types to specific protocol groups.
To open VLAN Membership screen perform the folling:
1.
Click Switch -> VLAN -> VLAN Port Settings
2.
The VLAN Port Settings screen is displayed as in Figure 3-64
Figure 3-64 VLAN LAG Settings
73
Advertisement
Table of Contents
