Table of Contents
Advertisement
The WGSW-24010 is a managed Ethernet Switch that can be controlled by the RS-232 console interface, telnet interface,
and Web interface. This chapter describer how to configure the Switch through these interfaces.
When you are ready to configure the smart functions of the Switch, make sure you had connected the supplied RS-232
serial cable to the RS-232 port at the front panel of your WGSW-24010 Switch and your PC.
3.1 Connect to PC's RS-232 serial port
Hyper Terminal
In Windows 98/2000/XP, launch "HyperTerminal", create a new connection, and adjust settings as below:
§
Baud per second: 38400
§
Data bits: 8
§
Parity: None
§
Stop bits: 1
§
Flow Control: None
3.2 Configure IP Address
Power on the WGSW-24010, the terminal will display that it is running testing procedures. After boot, the following screen
displayed.
3. CONSOLE CONFIGURATION
6
Advertisement
Table of Contents
