Pressure Zone Indicators - Arjohuntleigh citadel Instructions For Use Manual

Pressure Zone Indicators

Monitor patient airway and position during inflation / deflation
of mattress. Ensure patient and any patient support lines are
properly supported at all times.
Turning
Prior to engaging any mattress turn feature, make sure that
all side rails are fully engaged in their full upright and locked
position. Do not activate the turning feature on any mattress
system when patient restraints are in use.
The actual angle of rotation achieved by a patient is
dependent on many factors including: patient weight,
patient weight distributions, pressure settings and patient
positioning on the mattress surface. 20° is the target turn
angle, but will not be achieved by all patients based on the
variables mentioned above.
22
The pressure zone indicators will indicate the
individual pressure settings for each zone.
Solid green LEDs indicate relative pressure set
points for each mattress zone.
LEDs will flash when section is adjusting toward
target pressure.
Each zone is independently adjustable using up
and down arrows. The up arrows will increase
pressure; the down arrows will decrease pressure.
Patient Turn Right Button (nurse assist)
the patient approximately 20° to their right. An audible tone
will sound when the turn has completed.
Patient Center Button
turned position to flat.
Patient Turn Left Button (nurse assist)
the patient approximately 20° to their left. An audible tone will
sound when the turn has completed.
- Press to return patient from a
Citadel Patient Therapy System
- Press to rotate
- Press to rotate