5. Locate the foot extension cover plate (see figure 1, item 3), with
air hoses (figure 2, item 1) and electrical connectors (2) attached,
under the foot end of bed. Disconnect the air hoses and electrical
connectors from the foot extension cover plate.
2
1
Figure 2: Foot extension cover plate with air hoses and electrical connections
6. Remove cover plate by unscrewing two Philips Pan head screws (see
figure 1, item 4) on the underside of the cover. Place cover plate and
hardware in storage bag in case air mattress control unit is removed
later. The foot extension cover plate will need to be reinstalled to
secure air hoses and electrical connectors.
Electrical connectors must be connected to the air mattress
control unit when installed, or attached to the foot extension
cover plate if the air mattress control unit is not installed.
7. If not already installed, Install the air mattress control unit mounting
bracket (see figure 3, item 1) to the back of the air mattress control
unit (2), using the six hex head flush mount screws (4).
1
4
5
Figure 3: Air mattress control unit and mounting bracket
12
2
3
7
6
Citadel Patient Therapy System