Banner SureCross DX80 Quick Start Manual page 14

SureCross™ DX80 Quick Start Guide
P/N 128185 Rev A
DX80 Battery Replacement
Battery Replacement
To replace the lithum "D" cell battery in the
DX81 FlexPower battery kit,
When removing the battery, press the
battery towards the negative terminal
to compress the spring. Pry up on the
battery's positive end to remove from the
battery holder.
Properly dispose of your used battery by
taking it to a hazardous waste collection
site, an e-waste disposal center, or any
other facility qualifi ed to accept lithium
batteries.
As with all batteries, these are a fi re,
explosion, and severe burn hazard. Do not
burn or expose them to high temperatures.
Do not recharge, crush, disassemble, or
expose the contents to water.
Banner Engineering Corp. • Minneapolis, MN U.S.A.
14
www.bannerengineering.com • Tel: 763.544.3164
1. Remove the four screws mounting the
battery pack face plate to the body.
2. Remove the face plate.
3. Remove the discharged battery and
replace with a new battery. Verify
the battery's positive and negative
terminals align to the positive and
negative terminals of the battery
holder mounted within the case.
4. After replacing the battery, allow up
to 60 seconds for the device to power
up.