Banner SureCross DX80 Quick Start Manual page 13

Main Body Gasket
Check the main body gasket every time the
DX80 is opened. Replace the gasket when
it is damaged, discolored, or showing signs
of wear. The gasket must be:
• Fully seated within its channel along
the full length of the perimeter, and
• Positioned straight within the channel
with no twisting, stress, or stretching.
Rotary Switch Access Cover O-Ring
Check the rotary switch access cover
o-ring every time the access cover is
removed. Replace the o-ring when it is
damaged, discolored, or showing signs of
wear. The o-ring should be:
• Seated fi rmly against the threads
without stretching to fi t or without
bulging loosely, and
• Pushed against the fl anged cover.
When removing or closing the rotary switch
access cover, manually twist the cover
into position. Do not allow cross-threading
between the cover and the DX80 face.
Once the cover is in place and manually
tightened, use a small screwdriver (no
longer than fi ve inches total length) as a
lever to apply enough torque to bring the
rotary switch access cover even with the
DX80 cover surface.
Replacing O-Rings
Please refer to the list of replacement
parts on page 22 and contact Banner
Engineering with any questions.
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross™ DX80 Quick Start Guide
Maintenance and Parts Installation
13
Main Body Gasket
Rotary Access O-Ring
P/N 128185 Rev A