Opener - Dodge Journey 2018 User Manual

Rolling Code Devices
To determine if your device has a rolling code, a
good indicator is its manufacturing date. Typi-
cally, devices manufactured after 1995 have
rolling codes. A device with a rolling code will
also have a "LEARN" or "TRAIN" button lo-
cated where the antenna is attached to the
device. The button may not be immediately
visible when looking at the device. The name
and color of the button may vary slightly by
manufacturer.
NOTE:
The "LEARN" or "TRAIN" button is not the
button you normally use to operate the device.
Non-rolling Code Devices
Most devices manufactured before 1995 will
not have a rolling code. These devices will also
not have a "LEARN" or "TRAIN" button.
Programming HomeLink To A Garage Door

Opener

To program any of the HomeLink buttons to
activate your garage door opener motor, follow
the steps below:
48
NOTE:
All HomeLink buttons are programmed using
this procedure. You do not need to erase all
channels when programming additional but-
tons.
1. Place the ignition switch into the ON/RUN
position.
2. Place the garage door opener transmitter
1 to 3 inches (3 to 8 cm) away from the
HomeLink button you wish to program, while
keeping the HomeLink indicator light in
view.
3. Push and hold the HomeLink button you
want to program while you push and hold the
garage door opener transmitter button you
are trying to replicate.
4. Continue to hold both buttons and observe
the HomeLink indicator
HomeLink indicator light will flash slowly
and then rapidly. Once this happens, release
both buttons.
NOTE:
Make sure the garage door opener motor is
plugged in before moving on to the rolling code/
non-rolling code final steps.
Rolling Code Garage Door Opener Final Steps
NOTE:
You have 30 seconds in which to initiate rolling
code final step 2, after completing rolling code
final step 1.
1. At the garage door opener motor (in the
garage), locate the "LEARN" or "TRAIN"
button. This can usually be found where the
hanging antenna wire is attached to the
garage door opener motor. Firmly push and
release the "LEARN" or "TRAIN" button.
2. Return to the vehicle and push the pro-
grammed HomeLink button three times
(holding the button for two seconds each
time). If the garage door opener motor oper-
ates, programming is complete.
3. Push the programmed HomeLink button to
confirm that the garage door opener motor
light. The
operates. If the garage door opener motor
does not operate, repeat the final steps for
the rolling code procedure.