General Information - Dodge Journey 2018 User Manual

• For security, power window and power sunroof
operation (if equipped) are disabled when the
vehicle is in the Remote Start mode.
• The engine can be started two consecutive
times (two 15-minute cycles) with the key fob.
However, the ignition must be cycled to the
RUN position before you can repeat the start
sequence for a third cycle.

General Information

The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user's authority to operate the
equipment.
VEHICLE SECURITY ALARM — IF
EQUIPPED
The vehicle security alarm monitors the vehicle
doors and liftgate for unauthorized entry and the
Keyless Enter-N-Go Start/Stop button for unau-
thorized operation. While the vehicle security
alarm is armed, interior switches for door locks
are disabled. If something triggers the alarm,
the vehicle security alarm will provide the fol-
lowing audible and visible signals: the horn will
pulse, the headlights will turn on, the park
lamps and/or turn signals will flash, and the
vehicle security light in the instrument cluster
will flash.
To Arm The System
Follow these steps to arm the vehicle security
alarm:
1. Make sure the vehicle ignition system is OFF
(refer to "Starting The Engine" in "Starting
And Operating" for further information).
2. Perform one of the following methods to lock
the vehicle:
• Push lock on the interior power door lock
switch with the driver and/or passenger
door open.
• Push the lock button on the exterior Pas-
sive Entry Door Handle with a valid key fob
available in the same exterior zone (refer
to "Keyless Enter-N-Go — Passive Entry"
in "Getting To Know Your Vehicle" for fur-
ther information).
• Push the lock button on the key fob.
3. If any doors are open, close them.
To Disarm The System
The vehicle security alarm can be disarmed
using any of the following methods:
• Push the unlock button on the key fob.
15