Dodge Journey 2018 User Manual page 115

NOTE:
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is enabled
at this gear selector position, the system will
remain active until the vehicle speed is in-
creased to approximately 7 mph (11 km/h) or
above. The system will become active again if
the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors' field of view.
NOTE:
• The sensors can detect obstacles from ap-
proximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear bumper
while the vehicle is in REVERSE, a warning
will display in the instrument cluster display
only when "Sound and Display" is selected
from the Uconnect System.
• As the vehicle moves closer to the obstacle,
the instrument cluster display will show fewer
arcs and the sound tone will change from
slow, to fast, to continuous.
Refer to your Owner's
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Ca-
nadian Residents) for further information.
PARKVIEW REAR BACK UP CAMERA
— IF EQUIPPED
Your vehicle may be equipped with the
ParkView Rear Back Up Camera that allows you
to see an on-screen image of the rear surround-
ings of your vehicle whenever the gear selector
is put into REVERSE. The image will be dis-
played in the touchscreen display along with a
caution note to "CHECK ENTIRE SURROUND-
INGS" across the top of the screen. After five
seconds this note will disappear. The ParkView
camera is located on the rear of the vehicle
above the rear license plate.
When the vehicle is shifted out of REVERSE,
the rear camera mode is exited and the last
selected touchscreen appears again.
The camera image is also available in the rear-
Manual at
view mirror if the touchscreen display is unavail-
able.
If your vehicle is equipped with the Camera
Delay feature and it is turned on, the rear cam-
era image will be displayed for up to 10 seconds
when the vehicle is shifted out of REVERSE
unless the forward vehicle speed exceeds
8 mph (13 km/h), the transmission is shifted
into PARK, the X button on the camera display
screen is pressed, or the vehicle's ignition is
cycled to the OFF position.
Static grid lines will illustrate the width of the
vehicle while a dashed center-line will indicate
the center of the vehicle to assist with parking or
aligning to a hitch/receiver. The static grid lines
will show separate zones that will help indicate
the distance to the rear of the vehicle.
113