Dodge Journey 2018 User Manual page 113

NOTE:
In order to ensure proper operation, the Speed
Control System has been designed to shut down
if multiple Speed Control functions are operated
at the same time. If this occurs, the Speed
Control System can be reactivated by pushing
the Speed Control ON/OFF button and resetting
the desired vehicle set speed.
To Activate
Push the ON/OFF button. The Cruise Indicator
Light in the instrument cluster display will illu-
minate. To turn the system off, push the ON/
OFF button a second time. The Cruise Indicator
Light will turn off. The system should be turned
off when not in use.
WARNING!
Leaving the Speed Control system on when
not in use is dangerous. You could acciden-
tally set the system or cause it to go faster
than you want. You could lose control and
have an accident. Always leave the system
off when you are not using it.
To Set A Desired Speed
Turn the Speed Control on. When the vehicle
has reached the desired speed, push the SET (-)
button and release. Release the accelerator and
the vehicle will operate at the selected speed.
NOTE:
The vehicle should be traveling at a steady
speed and on level ground before pushing the
SET (-) button.
To Vary The Speed Setting
To Increase Speed
When the Speed Control is set, you can increase
speed by pushing the RES (+) button.
The driver's preferred units can be selected
through the instrument panel settings if
equipped. Refer to "Getting To Know Your In-
strument Panel" in the Owner's Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Ca-
nadian Residents) for more information. The
speed decrement shown is dependant on the
chosen speed unit of U.S. (mph) or Metric
(km/h):
U.S. Speed (mph)
• Pushing the RES (+) button once will result in
a 1 mph increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 mph.
• If the button is continually pushed, the set
speed will continue to increase until the but-
ton is released, then the new set speed will be
established.
Metric Speed (km/h)
• Pushing the RES (+) button once will result in
a 1 km/h increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 km/h.
• If the button is continually pushed, the set
speed will continue to increase until the but-
ton is released, then the new set speed will be
established.
To Decrease Speed
When the Speed Control is set, you can de-
crease speed by pushing the SET (-) button.
The driver's preferred units can be selected
through the instrument panel settings if
equipped. Refer to "Getting To Know Your In-
111