Turn Signals - Dodge Journey 2018 User Manual

Turn Signals

Move the multifunction lever up or down and
the arrows on each side of the instrument clus-
ter display flash to show proper operation of the
front and rear turn signal lights.
NOTE:
• If either light remains on and does not flash, or
there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
• A "Turn Signal On" message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal
on.
Lane Change Assist — If Equipped
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically
turn off.
INTERIOR LIGHTS
Courtesy/Interior Lighting
The interior lights come on when a door is
opened.
To protect the battery, the interior lights will turn
off automatically 10 minutes after the ignition
is moved to the LOCK position. This will occur if
the interior lights were switched on manually or
are on because a door is open. The Battery
Protection also includes the glove compartment
light. To restore interior light operation after
automatic battery protection is enabled (Lights
off), either place the ignition in the ON/RUN
position or cycle the light switch.
WIPERS AND WASHERS
The windshield wiper/washer control lever is
located on the left side of the steering column.
Multifunction Lever
The front wipers are operated by rotating a
switch, located at the end of the lever. For
information on using the rear window wiper/
washer, refer to "Rear Wiper Operation" in this
section.
Windshield Wiper Operation
Rotate the end of the lever upward, to the first
detent past the intermittent settings for low-
speed wiper operation. Rotate the end of the
lever upward to the second detent past the
intermittent settings for high-speed wiper op-
eration.
29