Gold's Gym CWTL05607.4 User Manual page 10

10. Locate the Latch Pin Assembly (21). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are
two collars, place one on each side of the
spring.) Next, insert the pin into the Latch
Housing (73). Then, tighten the knob onto the
pin.
11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to
adjust the walking belt (see pages 23 and 24).
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Remove the key from the console and unplug
the power cord.
Remove the indicated #8 x 3/4" Screw (3) and
the Access Door (76) from the back of the
Console Base (85).
2. Connect the wire on the receiver to the indicated
wire extending from the Console Base (85). Hold
the receiver so that the small cylinder is ori-
ented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on
the Access Door (76) with the two included small
screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (76) with the #8 x 3/4" Screw
(3). Discard the other wires included with the re-
ceiver.
10
Knob
73
Spring
Collar
Pin
85
76
Receiver
3
10
21
Wire
Small
Screws
Small
Cylinder