With Two #8 X 1" Tek Screws (83) As Shown - Gold's Gym CWTL05607.4 User Manual

5. Attach two Base Feet (82) to the Base (108)

with two #8 x 1" Tek Screws (83) as shown.

Insert the other Extension Leg (89) into the
Base (108) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.
Next, insert two 5/16" x 2 1/4" Bolts (65) into the
top of the Extension Leg, and firmly tighten the
Bolts into the Extension Leg Nuts.
6. With the help of a second person, carefully raise
the Right Upright (107) and the Left Upright (not
shown) to a vertical position.
Have the second person hold the console as-
sembly near the Right Upright (107) as shown.
Connect the Upright Wire (77) to the Console
Wire (66). See the inset drawing. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Remove the wire tie from the Upright Wire (77).
7. Insert the Upright Wire (77) and the Console
Wire (66) into the Right Upright (107).
Set the console assembly on the Uprights (84,
107). Be careful not to pinch the wires. While
a second person holds the console assembly,
attach it with four 5/16" x 1" Bolts (64) and four
5/16" Star Washers (8); start all four Bolts and
then firmly tighten all of them.
See page 13, and turn on the power as de-
scribed. (Note: The treadmill may automatically
rise to the maximum incline level and then re-
turn to the minimum level.) Next, see step 4 on
page 13, and adjust the incline to the lowest
level. Then, remove the key and unplug the
power cord.
5
108
82
83
67
6
Console
Assembly
Wire
66
Tie
77
7
Console
Assembly
77, 66
8
64
107
8
65
82
89
66
77
107
8
64
84