Gold's Gym CWTL05607.4 User Manual page 23

Raise the Uprights (84, 107) to the vertical position.
Remove the three #8 x 3/4" Hood Screws (7) from the
Motor Hood (41), and carefully pivot the Motor Hood
off.
Locate the Reed Switch (63) and the Magnet (46) on
the left side of the Pulley (47). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8 in. (3 mm). If necessary, loosen
the #8 x 1/2" Screw (33), move the Reed Switch
slightly, and then retighten the Screw. Reattach the
Motor Hood (not shown); make sure that the #8 x 3/4"
Hood Screws and the #8 x 3/4" Screws (not shown)
are inserted into the same holes from which they were
removed. Run the treadmill for a few minutes to check
for a correct speed reading.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-
move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the hex key, turn both idler
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 3 to 4 in. (8 to 10
cm) off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power cord,
insert the key, and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
84
Top
View
b
Idler Roller Bolts
23
7
41
33
63
1/8 in.
3–4 in.
107
7
47
46