Neuro App - Source Audio Aftershock Bass Distortion User Manual

1. Press the C
ONTROL
lit green.
2. Press and hold the C
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the
Aftershock. The easiest way to do this is to move the ring in the same way that you intend to
move it as you perform. The Aftershock will intelligently select the X or Y axis of the Hot
Hand automatically, based on the motion of the ring.
4. After setting Hot Hand range of motion, click the Aftershock's O
calibration is now complete, and the C
second). Now, it is time to map the Hot Hand to the effect parameters.
5. Move the knob(s) you wish to control with the Hot Hand to their minimum desired position,
then click the Aftershock's O
(about 4 blinks per second). Note that you may control one or more knobs with the Hot
Hand, up to four total knobs.
6. Move the knob(s) you wish to control with the Hot Hand to their maximum desired position,
then click the Aftershock's O
Note that you may control one or more knobs with the Hot Hand, up to four total knobs.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Note: The parameter range can be inverted by swapping the minimum and maximum position of the
knobs during calibration.
Reset Expression Control Mapping
To clear the expression control mapping (Expression or Hot Hand), first press the C
and turn off Control Input mode. The C
BUTTON
C I
ONTROL NPUT BUTTON
mapping.

Neuro App

The Neuro App is available as a free download for iOS and Android devices. Get the iOS version from
the App Store or the Android version from the Play Store. The Neuro App provides access to a
number of parameters that are not accessible on the control knobs, as well additional effect types. In
order to use the Neuro App, use the included 3.5 mm to ¼" TRS cable to make a connection between
the headphone jack on your mobile device and the Input 2 jack on the hardware. The Neuro App uses
special audio signals sent over your mobile device's headphone jack to remotely control the pedal.
Make sure the headphone volume on your mobile device is set to maximum when using the Neuro
App for the most reliable device to pedal communication.
SA246
I B to turn on Control Input mode. The C
NPUT UTTON
I
ONTROL NPUT BUTTON
/O F
N FF OOTSWITCH
/O F
N FF OOTSWITCH
until the C LED blinks. This clears all Expression, Hot Hand, and MIDI
ONTROL
Aftershock Bass Distortion User's Guide
until the C LED begins to blink slowly
ONTROL
LED will blink faster (about 2 blinks per
ONTROL
. The C LED will now blink even faster
ONTROL
. The C LED will now be lit solid green.
ONTROL
LED should be dark. Then, press and hold the
ONTROL
LED should be
ONTROL
/O F once. The
N FF OOTSWITCH
I
ONTROL NPUT
22