3. Preparation
3.1. Installation
3.1
Installation
Refer to the XYR 6000 Transmitter Quick Start Guide (document 34-XY-25-21) for installation, mounting
and wiring of your XYR 6000 SmartCET transmitter.
3.2
Configuration
The XYR 6000 SmartCET Transmitter contains the electronics interface compatible for connecting to the
OneWireless network. An operator uses the Wireless Builder application to configure blocks, to change
operating parameters, and to create linkages between blocks that make up the transmitter's configuration.
These changes are written to the transmitter when it is authenticated by a security key.
3.3
Connecting to network
Use Authentication Device to connect your transmitter to the OneWireless network. See page 28.
3.4
Calibrating the transmitter
Overview
The transmitter is calibrated at the factory. User calibration is unlikely to improve calibration and is not
recommended.
However, calibration is available if desired. For all calibration methods, Wireless Builder must first be
used to prepare the channel for calibration. For access to all calibration methods, refer to Wireless Builder.
Calibration choices:
User calibration
•
Restore to factory calibration
•
Linear Polarization Resistance check
•
12
OneWireless XYR 6000 SmartCET Corrosion Transmitter User's Manual
3. Preparation
Revision 3
6/24/08