5.1
Overview
Display modes
The transmitter has the following display modes.
Test. Appears briefly after power-up to self-test the display.
•
Connection status. Appears when transmitter is not fully connected to the OneWireless network. See
•
section 5.2.
PV display. Default mode of the transmitter displays the PV values and any status messages. See
•
below.
Quick view of transmitter identification parameters. Displays read-only parameters then returns to PV
•
display. See page 25.
Menu. See page 26.
•
Authentication Device
To navigate the transmitter displays and menus, hold the Authentication Device no more than 6" from the
transmitter and aim the infrared beam at the transmitter display while tapping the Device Local
Configuration buttons (Table 9). You can also use the PDA's buttons.
Authentication Device menus are described in section 5.6 starting on page 27.
Revision 3
OneWireless XYR 6000 SmartCET Corrosion Transmitter User's Manual
6/24/08
5. Operation
5. Operation
5.1. Overview
19