Transmitter Pv Display - Honeywell XYR 6000 User Manual

5.3

Transmitter PV display

In the PV display, the following information is displayed sequentially. For detailed descriptions of the
PV's, see page 39.
Item displayed
PV1 value
PV1 engineering units
PV1 status
Device status
PV2 value
PV2 status
PV3 value
PV3 units
PV3 status
PV4 value
PV4 status
Revision 3 OneWireless XYR 6000 SmartCET Corrosion Transmitter User's Manual
6/24/08
Example
1 +80.0 The General Corrosion Rate is the average or
general corrosion rate. Range: 0 – 250 mil/year
(0 - 6.35 mm/yr.)
mPY
Mils per year (mPY) or millimeters per year
(mmPY).
BAD See Table 6. If no PV status is displayed (blank)
then the PV value is good.
LOW BATT See Table 7. If no device status is displayed
(blank) then the device status is normal.
If two or more device status messages are in
effect they are displayed alternating with the PV
values.
2 +0.50 Pitting Factor (also referred to as localized
corrosion indicator). Range: 0 – 1. Unitless.
UNC See Table 6. If PV status is not displayed then
the PV value is good.
3 +26.50 B value, also known as the Stern-Geary
constant. Range: 0 to 200 typical.
mV Millivolts per decade
OUT SVC See Table 6. If PV status is not displayed then
the PV value is good.
4 +404.0 Corrosion monitoring index. Unitless. Normal
range is 0 – 2000.
See Table 6. If PV status is not displayed then
the PV value is good.
5. Operation
5.3. Transmitter PV display
Details
21