Basic Hardware Connection; Network Connection; Output Connection; Hard Disk Installation - HIKVISION Blazer Express 16 Quick Start Manual

Basic Hardware Connection

Before you can access the station via network, you need to properly power on the
station and connect it to network.

Network Connection

Note: Consult your network administrator before installing the station to avoid
possible network conflicts.
Use the network port on the rear panel and a network cable with RJ-45 connectors to
connect the station to your network.

Output Connection

Connect a VGA cable or HDMI
on the station.
Connect the VGA cable or HDMI

Hard Disk Installation

Before you start:
Disconnect the power from the Blazer Express before installing a hard disk drive
(HDD). A factory recommended HDD should be used for this installation.
Tools Required: Screwdriver.
Steps:
1. Remove the cover from the Blazer Express by unfastening the screws on the
back and side.
2. Install the HDD using the provided screws and fasten the screws on the bottom
to fix the HDD.
3. Connect the HDD to the motherboard of the Blazer Express with the included
data cable.
Quick Start Guide of Blazer Express Station
TM
cable to the video out interface (VGA or HDMI
TM
cable to the display unit.
6
TM
)