4. Check the Link mode of the SFP port if the link fails.
It is recommended to use PLANET SFPs on the Industrial PoE+
Switch. If you insert an SFP transceiver that is not supported, the
Industrial PoE+ Switch will not recognize it.
Note
3.4 Removing the Transceiver Module
1. Make sure there is no network activity by consulting or checking with the
network administrator. Or through the management interface of the switch/
converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the lever of the MGB series module to a horizontal position.
4. Pull out the module gently through the lever.
MGB Series
Transceiver
Never pull out the module without pulling the lever or the push
bolts on the module. Directly pulling out the module with force
could damage the module and the SFP module slot of the Industrial
Note
PoE+ Switch.
18
Figure 2-4: Pull Out from the Transceiver