Power Supply; Power Supply Failure - Supermicro 6039P-E1CR16L User Manual

SuperStorage Server 6039P-E1CR16H/L User's Manual

Power Supply

The 6039P-E1CR16H/L has a 1200 watt redundant, hot-swappable power supply consisting of
two power modules. Each power supply module has an auto-switching capability that enables
it to automatically sense and operate at a 100V - 240V input voltage.

Power Supply Failure

If either of the two power supply modules fail, the second module takes the full load and allows
the system to continue operation without interruption. The Power Fail LED illuminates and
remains on until the failed module has been replaced. Replacements can be ordered directly
from Supermicro (see contact information in the Preface). The power supply modules have
hot-swap capability, so you can replace the failed module without powering down the system.
Removing/Replacing a Power Supply Module
1. Unplug the power cord from the failed power supply module.
2. Push the release tab on the back of the module as illustrated.
3. Pull out the module using the handle provided.
4. Replace the failed module with another of the same model.
5. Push the new module into the power bay until it clicks into the locked position.
6. Plug the AC power cord back into the module.
Figure 3-14. Removing/Replacing a Power Supply
Release Tab
42