Table of Contents
Advertisement
3. Connect cables to the PCB backplane. Route the cables into the chassis and through
the opening under the power supplies.
4. Insert the drive cage assembly into the chassis while carefully following the cables.
Secure the cage with screws through the bottom of the chassis.
4
Figure 3-11. Installing Rear Hot-Swap Drive Tray
5. Attach power and data cables to the power distributor and the motherboard.
6. Slide two 2.5" hard drives mounted in hard drive carriers into the tray.
Chapter 3: Component Installation and Maintenance
Figure 3-12. Inserting Rear Drives
39
Advertisement
Table of Contents
