Assembling The Processor Package - Supermicro 6039P-E1CR16L User Manual

Assembling the Processor Package

Attach the processor to the narrow processor clip to create the processor package.
Caution: Exercise extreme caution when handling the CPU. Do not touch the underside of
the CPU to avoid damaging it. Wear ESD gloves when handling components.
1. Locate pin 1 (A), which is the triangle on the top of the narrow processor clip. Also
locate notch B and notch C on the processor clip.
2. Locate pin 1 (A), which is the triangle on the underside of the CPU. Also, locate notch B
and notch C on the CPU as shown below.
3. Align pin 1 of the CPU with pin 1 of the narrow processor clip. Once they are aligned,
carefully insert the CPU into the processor clip by sliding notch B of the CPU into notch
B of the processor clip. Then, slide notch C of the CPU into notch C of the processor
clip.
4. Examine all corners of the CPU to verify that it is properly seated and secure on the
processor clip.
The processor package assembly is created.
CPU (Upside Down)
w/CPU LGA Lands up
B
A
Align Notch B of the CPU
and Notch B of the Processor Clip
Align CPU Pin 1
Processor Package Assembly for the non-F Model Processors
Chapter 3: Component Installation and Maintenance
C
Align Notch C of the CPU
and Notch C of the Processor Clip
Pin 1
C
CPU/Heatsink Package
B
(Upside Down)
A
(with CPU mounted on the Processor Clip)
29
B
Allow Notch B to
latch on to CPU
A
Allow Notch C to
latch on to CPU
C