Installation Conditions; Inlet And Outlet; Bends In 2 Or 3 Dimensions; T-Section - KROHNE OPTIFLUX 1000 Quick Start Manual

OPTIFLUX 1000

2.8 Installation conditions

2.8.1 Inlet and outlet

Use straight inlet and outlet pipe sections to prevent flow distortion or swirl, caused by bends
and T- sections
Figure 2-5: Recommended inlet and outlet section
1 Refer to chapter "Bends in 2 or 3 dimensions"
2 ≥ 2 DN

2.8.2 Bends in 2 or 3 dimensions

Figure 2-6: 2 and 3 dimensional bends, in front of flowmeter
1 Bends in 2 dimensions: ≥ 5 DN; bends in 3 dimensions: ≥ 10 DN

2.8.3 T-section

Figure 2-7: Distance behind a T-section
1 ≥ 10 DN
01/2013 - 4002298501 - QS OPTIFLUX 1000 R04 en www.krohne.com
INSTALLATION
2
9