Figure 5 Back Panel Features - Fluke 6050H User Manual

6050H Calibration Bath
User's Guide

Figure 5 Back Panel Features

26
(4) The control probe plugs into the bath at the socket on the back of the bath
labelled "PROBE".
(5) If the bath is supplied with a serial RS-232 interface, the interface cable is
attached to the back of the bath at the connector labelled "RS-232".
(6) If the bath is supplied with a GPIB IEEE-488 interface, the interface cable
is attached to the back of the bath at the connector labelled "IEEE-488".
(7) The drain is for factory use only, but must be tightly sealed when the bath is
in use.