Authorized Service Centers - Fluke 6050H User Manual

Calibration bath

Hide thumbs Also See for 6050H:

User manual (68 pages)

Table Of Contents

Table of Contents

6050H Calibration Bath

User's Guide

1.3

• Under filling the bath may reduce the bath performance and may possibly

damage the bath.

• When calibrating PRTs always follow correct calibration procedure and

calibrate from high temperatures to low temperatures with the appropriate

triple point of water checks. Never immerse a wet or cold PRT into a bath

filled with hot fluid. Severe damage to the PRT may result as well as per-

sonal injury to the calibration technician.

• This bath is not designed to be portable. Therefore, moving the bath once

it has been installed should be kept to a minimum. NEVER MOVE A

BATH THAT IS FULL OF "HOT" FLUID. This action could be ex-

tremely dangerous and could result in personal injury to the person mov-

ing the bath. If the bath is going to be placed in an area where it may need

to be moved frequently, Hart Scientific sells a special cart designed to ac-

commodate the bath. However, even with a cart the bath should not be

moved full of "hot" fluid. The fluid can splash causing injury or if the

bath and cart tip, the "hot" fluid could cause damage to the surrounding

area and personnel.

• If the bath must be moved, allow the salt to solidify and cool. Care must

be used when moving the bath with the fluid solidified in the bath. The

control probe can easily be damaged. Two people are required to safely

move the bath. One person should lift the bath by the tower, while the sec-

ond person lifts from underneath the bath tank.

• The control probe must be inserted through the lid into the bath fluid and

plugged into the socket at the back of the bath. DO NOT operate the bath

without the control probe properly inserted and attached. The bath will

not operate correctly without the control probe. Injury to operating per-

sonnel and permanent damage to the bath could occur.