Table of Contents
Advertisement
6050H Calibration Bath
User's Guide
1.2
1.2.1
2
Symbol
Description
Canadian Standards Association
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-1 re-
fers to the level of Impulse Withstand Voltage protection provided. Equipment of
OVERVOLTAGE CATEGORY II is energy-consuming equipment to be supplied from
the fixed installation. Examples include household, office, and laboratory appliances.
C-TICK Australian EMC Mark
The European Waste Electrical and Electronic Equipment (WEEE) Directive
(2002/96/EC) mark.
Safety Information
DISCLAIMER: Hart Scientific manufactures baths for the purpose of
temperature calibration. Baths used for applications other than calibra-
tion are used at the discretion and sole responsibility of the customer. Hart
Scientific cannot accept any responsibility for the use of baths for any ap-
plication other than temperature calibration.
Use this instrument only as specified in this manual. Otherwise, the protection
provided by the instrument may be impaired.
The following definitions apply to the terms "Warning" and "Caution".
• "WARNING" identifies conditions and actions that may pose hazards to
the user.
• "CAUTION" identifies conditions and actions that may damage the in-
strument being used.
WARNINGS
To avoid personal injury, follow these guidelines.
GENERAL
• Appropriate personal safety protection should be worn by the operator at
all times while using the bath.
• Hart Scientific does not recommend that user's drain the salt from the
bath. Hart Scientific provides the service of draining salt from the bath. If
draining the bath salt is necessary, contact an Authorized Service Center
(see Section 1.3) for an RMA and instructions on returning the bath. In-
sure that the control probe is removed from the bath before the salt solidi-
fies. If the control probe is not removed before shipping the bath, the
Advertisement
Table of Contents
