Linefeed; Ieee-488 Parameters; Ieee-488 Address - Fluke 6050H User Manual

6050H Calibration Bath
User's Guide
9.12.4
9.13
9.13.1
44

Linefeed

The final parameter in the serial interface menu is the linefeed mode. This pa-
rameter enables (on) or disables (off) transmission of a linefeed character (LF,
ASCII 10) after transmission of any carriage-return. The linefeed parameter is
indicated by,
Serial linefeed parameter
LF
Press "SET" to access the linefeed parameter.
LF= On Current linefeed setting
The mode may be changed using "UP" or "DOWN" and pressing "SET".
LF= OFF New linefeed setting

IEEE-488 Parameters

Baths may optionally be fitted with an IEEE-488 GPIB interface. In this case
the user may set the interface address within the IEEE-488 parameter menu.
This menu does not appear on baths not fitted with the interface. The menu is
indicated by,
IEEE-488 parameters menu
IEEE
Press "SET" to enter the menu.

IEEE-488 Address

The IEEE-488 interface must be configured to use the same address as the ex-
ternal communicating device. The address is indicated by,
IEEE-488 interface address
AddrESS
Press "SET" to access the address setting.
Current IEEE-488 interface address
Add= 22
Adjust the value with "UP" or "DOWN" and then use "SET" to set the address
to the displayed value.
New IEEE-488 interface address
Add= 15