Troubleshooting Your Analyzer; Resetting And Powering The Analyzer Completely Off; Resetting The Analyzer; Forcing Power Off - Fluke OptiView Getting Started Manual

Troubleshooting Your Analyzer

Resetting and Powering the Analyzer Completely Off

If you suspect the Windows environment has locked up, you may have to reset
the OptiView Integrated Network Analyzer. This is done by pressing the Reset
button. If you are not sure if the Windows environment or the analyzer
(hardware) has locked up, you may have to completely power down the
analyzer by forcing the power off as described below.

Resetting the Analyzer

The Reset button resets the Windows portion of the analyzer without shutting
down the data acquisition board. The Reset button should only be used if the
Windows environment has stopped responding.

Forcing Power Off

Power can be forced off by pressing and holding the On/Off button for
approximately 7 seconds.
Figure 7. Reset Button Location
Index
(continued)
apo05f.eps
15